[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. Should any solid object or liquid fall into the cabinet, unplug the receiver and have it checked by qualified personnel before operating it any further. Before operating the receiver, check that the operating voltage is identical with your local power supply. [. . . ] This mode creates five sets of virtual speakers surrounding the listener at a 30° angle of elevation. Be sure to set the game machine to stereo mode when using game software with stereo sound capabilities. The effects provided by the virtual speakers may cause increased noise in the playback signal. When listening to sound fields that employ the virtual speakers, you will not be able to hear any sound coming directly from the rear speakers. Use the buttons on the front panel to operate the following modes Button) Automatically detects the type of audio signal being input (Dolby Digital, Dolby Pro Logic, or standard two channel stereo) and performs the proper decoding if necessary. This mode presents the sound as it was recorded/encoded, without adding any effects. Standard two channel (stereo) sources completely bypass the sound field processing. Set the tone to OFF while using this mode to hear the source sound exactly as it was recorded. This allows you to play any source using only the front left and right speakers. No sound is output from the sub woofer when the 2 CHANNEL mode is selected. To listen to two channel (stereo) sources using the front left and right speakers and a sub woofer, use the AUTO FORMAT DECODING mode. 1 ; DIGITAL This indicator lights up when a sound field other than 2 CHANNEL is selected and the unit is decoding signals recorded in the Dolby Digital (AC-3) format. * * However, this indicator does not light when the recording format is 2/0 or 2/0 Pro logic. 8 Tuner indicators These indicators light up when using the receiver to tune in radio stations, etc. 9 Playback channel indicators The letters light up to indicate the channels being played back. L: Front Left R: Front Right C: Center (monaural) LS: Left Surround RS: Right Surround S: Surround (monaural or the rear components obtained by Pro Logic processing) The boxes around the letters light up to indicate the speakers used to playback the channels. LFE will light up when the disc being played contains the LFE (Low Frequency Effect) channel and when the sound of the LFE channel signal is actually being reproduced. 2 PRO LOGIC Lights up when the receiver applies Pro Logic processing to two channel signals in order to output the center and surround channel signals. ** ** However, this indicator does not light if the center and rear speakers are set to "NO", or the SPEAKER button is set to "OFF" and the A. 3 OPT Lights up when the source signal is a digital signal being input through the OPT terminal. 4 COAX Lights up when the source signal is a digital signal being input through the COAX terminal. Note When playing a DTS format disc, be sure that you have made digital connections and that INPUT MODE is NOT set to ANALOG (see 3 on page 23). [. . . ] Anslut laserskivspelaren först till en RF-demodulator och sedan den optiska eller koaxiala, digitala utgången på RF-demodulatorn till OPTICAL eller COAXIAL DVD/LD IN på denna receiver. När en MD-spelare, som har anslutits till en dator, ansluts till denna receiver via styrkopplingarna CONTROL A1 : observera att du inte kan styra receivern när du använder Sonys program MD Editor för att styra MD-spelaren. Om du har fristående ljudkomponenter (utom PHONO) Använd ljudkablarna för att ansluta LINE OUT­ kontakterna på CD­spelaren, kassett­ eller MD­däcket till AUX AUDIO IN­kontakterna på mottagaren, så kan du lyssna till stereokällor med surroundljud. Anslut högtalartrådarna rätt: + till + och ­ till ­. [. . . ]